Building Blocks · World · Chapter 4 of 7 · 4 min read
What your legs feel
The world is there to be felt as well as seen. A climb should push back, cobbles should cost you, a wheel should give you a rest. This chapter is about the sum that turns the road into resistance and your power into speed.
Three things to push against
A rider at a steady speed works against three forces: the air, the tyres on the road, and gravity. Sports science has had a tested formula for this for decades:
air = ½ρ·CdA·(v + w)²
rolling = m·g·Crr·cos θ
climbing = m·g·sin θv is your speed, w the headwind, ρ the density of air, CdA your size against the wind, m you and the bike, g gravity, Crr the rolling resistance of the surface, θ the slope.
Martin and colleagues tested a model of this kind against power meters on a real road and found the two agreed to within a few watts.
BlockRide runs the formula in both directions, many times a second. From your power and the road it works out your speed. And about once a second it tells your trainer what the road is doing now: the gradient, the rolling resistance, the wind and how much air you are pushing.
Gradient
On a climb, gravity takes over the sum. The climbing part grows with your weight and the slope, and at climbing speeds the air hardly matters. That is why watts per kilogram decide a climb and plain watts decide a flat road.
Your trainer can't always follow the whole slope. A real 12% ramp needs gears many bikes on a trainer don't have. Trainer difficulty sets the share of the real gradient the trainer applies, and descents are always sent at half of that.
The setting changes what you feel and not what you ride. Your speed in the game always comes from your power and the full gradient. At a lower difficulty the same climb takes the same watts and the same time. You simply turn an easier gear to do it.
Surface
Rolling resistance is the energy lost as tyres and road deform against each other. On smooth asphalt it is small. On a rough surface more of your power goes into shaking the bike and you.
BlockRide has four surfaces: asphalt, gravel, cobbles and dirt. When your GPX file carries surface tags, the road uses them. Each surface has its own rolling resistance, lowest on asphalt and highest on cobbles, and a wet road adds a little to any of them.
Look at the formula to see what that means. The rolling part grows with speed but not with its square, so a rough surface hurts most where you are fast and the road is flat. A cobbled sector on a flat road can cost what a gentle climb costs. On a steep gravel climb the surface is a small extra on top of gravity.
Air
The air part grows fastest of all. Wind counts as extra speed through the air, so a headwind is expensive and a tailwind is a gift. Real weather explains where the wind comes from.
A draft works on the same part of the sum from the other side: behind another rider your CdA is smaller. The draft in the Challenges series goes through it.
When the road stops pushing
In a planned workout the trainer has a different job. It holds the watts of the current step, whatever the road does, so the session comes out as written. The world is still there and you still travel through it, but the hill no longer changes the resistance.
And a trainer that can't set resistance, or a ride on a power meter alone, gets the speed side of the sum only. The game still moves you at the speed your power earns on that road. You just don't feel the road change.
The formula describes a steady rider. The game also accounts for the effort of speeding up and the speed you carry into a rise, which is why a short ramp taken fast feels easier than its gradient suggests.