Building Blocks · Training · Chapter 5 of 11 · 4 min read
Fitness, fatigue and form
One ride's load says little. What matters is the pattern over weeks. BlockRide turns your daily loads into three numbers that answer three questions: how much training are you used to, how tired are you now, and are you ready for a hard day?
One session, two effects
In the 1970s Eric Banister and colleagues proposed that every training session does two things. It leaves a small, long-lasting gain, and a larger, short-lived tiredness. Performance at any moment is the first minus the second. The idea has been used by coaches and training software ever since.
BlockRide keeps a running average for each effect. Each day, the average moves a step towards that day's load:
T sets how fast the average reacts. Fitness uses a long one, so it rises slowly and falls slowly. Fatigue uses a short one, so it jumps after a hard week and drops after a few easy days. The published versions of this model commonly use about six weeks for fitness and about one week for fatigue. BlockRide's values are in that family.
Reading the three numbers
- Fitness is the daily load you are used to. A fitness of 50 means your recent weeks average out to about 50 a day, or 350 a week.
- Fatigue is the same for the last few days. After a training camp it is far above fitness. After a rest week it is below.
- Form is the gap. Negative means you are carrying tiredness, which is normal while building. Around zero or a little above means fresh. Far above zero for long means you are losing fitness.
On your account, form sits on a scale with four bands: Overreached, Building, Fresh and Detraining. Most of a training block should be spent in Building. The days before an event should move into Fresh. That move is the whole point of a taper: fatigue falls faster than fitness, so for a short while you keep most of the gain and lose most of the tiredness.
Per tank, too
BlockRide runs the same sums for each tank from chapter 4. You have a Cruise fitness, a Push fitness and a Burst fitness. A rider who has done months of long steady rides can be very fit in Cruise and nearly untrained in Burst. The account page shows this week's load in each tank against your usual week, so a gap is easy to see.
Where the numbers start
A new rider has no history, and a fitness of zero would make the first plan absurdly easy. When your profile is made, BlockRide counts the rides you already have from the last months, and any sessions you import. If you come from another tool you can set a starting fitness by hand, or pick a level that describes your riding.
What these numbers are for
Fitness is bookkeeping. It is an average of what you did, not a measurement of what you can do. Banister's model, fitted to real athletes, predicts performance only roughly, and Busso showed that how much a session tires you depends on how much training came before it. Later teaching papers, such as Clarke and Skiba's, are clear that the model is a useful simplification.
BlockRide therefore splits the work. What you can do comes from measurement: your profile and its stack-ups. How much you should do next comes from fitness, fatigue and form. The plan in the next chapter uses your fitness to decide where to start, and your form to decide when to push and when to hold back.
- Calvert TW, Banister EW, Savage MV, Bach T. A systems model of the effects of training on physical performance. IEEE Trans Syst Man Cybern, 1976.
- Busso T. Variable dose-response relationship between exercise training and performance. Med Sci Sports Exerc, 2003.
- Clarke DC, Skiba PF. Rationale and resources for teaching the mathematical modeling of athletic training and performance. Adv Physiol Educ, 2013.
- Allen H, Coggan A. Training and Racing with a Power Meter. VeloPress.